The process was - First a tape mold of a female head was made, which then was inflated with a balloon, A release agent was then applied. Next came a number of sheets of impregnated fiber cloths and the hinge with latch. Once set, the balloon was deflated, and the rear panel cut open. Then the entire helmet was machined down with a grinder to smoothen the inside while the outside was shaped and sanded, A large hole was cut with a hole saw into the helmet to gain access to the mouth!. Next, the helmet was painted black. The entire inside of the helmet was then fitted with a neoprene liner for comfort. The neck piece had a heavy liner put around the circumference, to aid in long-term comfort! Snaps were installed for a snap-in penis gag, as a torment device, or to hold a ball type feeder gag.
Suggested improvements: Full neck collar piece with shoulder flare (to help support helmet), larger loop hook at the crown of the helmet (for added securing with chains), Two drilled holes for nasal tubes, Two padded earmuffs with headphones and adjustable locks to help secure head size differences.